Roberts Carpet Tools Safe Tuk Carpet Tucker 10-522

Product Information

Carefully nail the gripper down butting up extra lengths where necessary if you have a concrete floor and the nails won’t fasten then you can use gripper adhesive.

For doorways, cut the carpet to be in line with the next flooring’s edge. And fit it under a threshold bar with a screwdriver or bolster. There aren’t many methods for calculating the amount of carpet you need. Simply calculate the area and go from there. What Is the Recommended Amount of Extra Carpet? Roll out the first length of underlay so that it butts up against the inside edge of the carpet gripper cutting it to size if needed and use a staple gun to fix the underlay to the floor at 30 to 40-centimeter centers. We always recommend that you get one of our recommended fitting partners to lay your carpet for you when you buy from Tapi, but if you’re keen to give this a hand yourself, then here are some of our top tips, a step-by-step guide to laying carpet and dealing with carpet grippers. And, if you find yourself left with excess carpet, have a read of our handy guide on how to upcycle your offcuts! How to lay a carpet Push the sheets together and nail the edges where the sheets meet first. When you finish the first row of boards the last one will need to be cut to size.

Carpet Size

Floor lining paper will help protect the underlay and carpet from dust coming through the sub floor.

Finally, hook the carpet to the grippers along the remaining longest side first and then the remaining short side. Then cut the carpet so that it ends just before the middle of a threshold bar on the room side of the bar.Having already worked out the area earlier you’re ready to cut the carpet to the approximate size including any allowances for final trimming.

Use a cutting board under the carpet so that you don’t damage the threshold bar as you cut. make sure you get the right kind of threshold bar that works with the floor surface of the adjoining room. Ensure that you mark any areas where pipes or wires run underneath the subfloor, as you won’t want any of the nails from the carpet grippers piercing these! For these areas, you’ll need to use carpet gripper glue instead of the nails, so marking them out on the floor means you can easily find them again. How far should carpet grippers be from skirting boards?

The doorway will need a threshold strip or metal edging bar. And the type will depend on the type of floor in the next room i.e. laminate or carpet. Place the carpet stretcher about 25mm from the skirting with its teeth facing downwards. To hook the carpet onto the gripper on both sides of the corner, press the padded end with your knee. Typically, it can save you money, but that isn’t always the case. Use the factors above to estimate the carpet installation cost. Then, compare it to the cost of the needed tools for a DIY job, and there’s your answer! Carpet Size