Being ‘water permeable’ is very important because it means that water/rain won’t lodge on your patio; it will drain down through the joints that have been jointed with Joint-It Simple to prevent your patio from flooding. Slipbond has been formulated with extended workability for fixing brick slips and natural stone to a range of substrates. If you decide to power-wash your patio, the water won’t lift Joint-It Simple out of the joints once the manufacturers’ guidelines have been met – it will drain down through the joints, which is why we say that Joint-It Simple is power-washer resistant. These highly porous stones would benefits from being pre-sealed to prevent drawing any of the colour of Joint-It Simple into the stone.

Manufacturers We are proud to partner with the leading manufacturers in the construction materials industry and be an approved supplier. Ensure the joints, all of the joints are cleaned out to a minimum depth of 20mm and a width of at least 3mm up to 25mm is recommended. Our simple to use, sweep-in jointing grout means gets the job finished faster and stands the test of time. Please don’t be alarmed if there is any slight colour enhancement on your slabs as this will disappear after a few weeks. We strongly recommend Limestone and Flamed/Honed Black Granite are pre-sealed prior to application of Joint-It Simple.First time using Joint-it simple, to say I was impressed with the product would be an understatement.

If the temperature is forecast to drop near freezing or below freezing within 12 hours of application, Joint-It Simple should not be used, because the water will freeze as it hits the ground making it too difficult to sweep the product into the joints. At an average temperature of around 20° Celsius, Joint-It Simple should feel hard-to-touch after approximately 4 hours. This is because Joint-It Simple is a water permeable product, meaning water is able to move through it. The paving slabs must be wet before you tip out the product, otherwise Joint-It Simple may accentuate any natural discolouration in your paving slabs.

Slate and Granite paving slabs, even those from the same batch, may absorb water at different rates. Rain won’t crack the joints between your paving slabs which is why we say that Joint-It Simple is weed resistant. In cases where insufficient water has been used, Joint-It Simple may leave a residue that accentuates any natural discolouration in the stone. To get the best results from Joint-It Simple, joints must be a minimum width of 3mm and a depth of 25mm for the joint to have stability when it is set.

I have no complaint against the product whatsoever and I have spoken to someone from the seller who was extremely helpful. We recommend cleaning your patio and joints with Joint-It So Clean or Joint-It Algae Remover every 3 to 4 months to keep it looking new. You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice.Our unmatched range includes everything to enhance any garden and most can be used as indoor tiles or outdoor slabs.

The amount to use depends on the depth, width and length of the joints along with the size of the paving slab, rule of thumb for a standard paving slab is roughly 12sqm per 15kg of Joint It Simple. Our natural sands harden on contact with air, so simply wet the area, brush in the product, and leave it to do the rest. Ideal for Porcelain, Sandstone, Limestone, Slate, Concrete, Yorkstone, Granite, Ceramic and Quartz paving slabs and setts. Heavy Traffic Pro Jointing Mortar - 2-Part Epoxy Resin Mortar System - suitable for vehicle areas up to 7. Sweeping in the jointing compound means getting the job finished faster and better with a more uniform job that stands the test of time.This product is water permeable, allowing rain to seep into the ground rather than pool on the surface.