Normal: The device is working normally and the connection to the cloud server is normal.The device can be only controlled through the APP in this mode.

This is the Forum CUL-40039 Culina Konect Wireless On/Off Kinetic Switch Non-Dimmable Wi-Fi Module - a wifi and RF wireless receiver. Unregistered: The device has not been bound to account. The device needs to be bound to the eWeLink account to connect to the cloud server. You can bind the device by tap “Add Device” in the eWeLink APP. No Server: The device has been connected to the router, but it cannot connect to the server (also known as”cannot access the Internet”). The flashing of the Wi-Fi status light is in a cycle of 2 seconds, as shown in the figure, the low-level light is on and the high-level light is off. Detailed explanation of each status: Main switch for 4-channel pin, active low. APP configuration pin, when the low level> 5S, enter the pairing mode.

Energy Saving

The upper and lower layers of the PCB where the module is placed should not be routed as much as possible. Do the copper-clad processing, and the PCB from the module antenna to the nearest pin of the module should be hollowed out as much as possible.

External reset signal: active at low level, externally need to pull up a 10K resistor to 3.3V, and connect a 100nF capacitor to ground. Place the module’s power supply (VCC) pin capacitance and other module pin capacitances, resistors as close as possible to the module pins, and the tracepath should be short.

You can only compare up to four products at a time.

Count downtimer: The count down is to facilitate the user to perform one-time timing operations, such as turn on/off the device after 30 minutes. It is very convenient to turn off a device after running a period of time. This device supports up to 24 hours of count down. Strong signal up to 40m range outdoors, 15m indoors for plasterboard, 8m indoors for concrete or glass The relay switch for the first channel: active high, power-on default low level. Note: As a switch button, there will be a period of high level at the moment of power-on, which requires a pull-down (1~4.7K) resistor to ground. The relay switch for the fourth channel, active low. APP configuration pin, when the low level> 5S, enter the pairing mode. Note: The chip configuration pin needs to pull down (1~4.7K) resistor to ground.

The Gateway acts as a conduit for any RF Quinetic products to be linked together thus creating a hybrid system for both RF and WiFi connectivity. This item is suitable for use with single, double and triple kinetic switches plus a single switch key fob. WiFi and RF Wireless Receiver Non-Dimmable in Matt White - Specs PSF-B04 module can be used as a 4-channel switch, which can control the switch locally or remotely through APP. The switch for the third channel, active low. APP configuration pin, when the low level> 5S, enter the pairing mode. The flashing mode of the Wi-Fi status light on the device represents the its current network working status. The specific status includes the following seven types:The 40039 is a single channel Wi-Fi relay switch receiver. Part of the Culina Konect system from Forum Lighting. This a completely wireless switching system converts the kinetic energy produced by physically switching the switch into electrical energy to control your lights via remote switch and receiver. The switch for the first channel, active low. APP configuration pin, when the low level> 5S, enter the pairing mode.